These quality Supply Guy design metal stamps will make a lasting impression on your jewelry and are manufactured to the highest standard for durability and alignment. Designs are made from heat-treated tool steel and are rated for use on stainless steel.

Tool Size: 9mm Square Tool

Impression Size: 5mm

Quantity Included: 1 Stamp

Features: Rated for Use on Stainless Steel

Design stamps can be tricky so for best results follow these simple steps:

1. Practice on cheaper metal before using higher end metals like Sterling Silver or Gold Filled.

2. Make sure there is no padding under your bench block.

3. Make sure you are working on a stable table.

4. Use a steel faced or brass hammer which weighs at least 1-2 pounds depending on the complexity and size of the design.

5. Hit the stamp more than once, but hold it steady making sure you don't shift at all between hits.

Our decorative square shank stamps are made of hardened steel for decorating all types of jewelry items. Their usage gives an artistic effect and enables the designer to personalize each piece. Each stamp contains easy identification with the image etched on the side.

Impression Size: 6mm

Our decorative square shank stamps are made of hardened steel for decorating all types of jewelry items. Their usage gives an artistic effect and enables the designer to personalize each piece. Each stamp contains easy identification with the image etched on the side.

Impression Size: 6mm

These quality Supply Guy design metal stamps will make a lasting impression on your jewelry and are manufactured to the highest standard for durability and alignment. Designs are made from heat-treated tool steel and are rated for use on stainless steel.

Tool Size: 9mm Square Tool

Impression Size: 5mm

Quantity Included: 1 Stamp

Features: Rated for Use on Stainless Steel

Design stamps can be tricky so for best results follow these simple steps:

1. Practice on cheaper metal before using higher end metals like Sterling Silver or Gold Filled.

2. Make sure there is no padding under your bench block.

3. Make sure you are working on a stable table.

4. Use a steel faced or brass hammer which weighs at least 1-2 pounds depending on the complexity and size of the design.

5. Hit the stamp more than once, but hold it steady making sure you don't shift at all between hits.